When there are a few months left before Apple’s new iPhone 14 launch conference, mobile phone protective case manufacturers usually get the iPhone 14 mold in advance, and can determine the appearance of the new phone in advance. Now the Internet has also leaked the front iPhone 14 Pro Max mold and mold opening. The design drawings further confirmed that the iPhone 14 Pro went to the bangs and switched to a punch-hole screen, presenting a unique “exclamation mark” shape.
It can be clearly seen that the iPhone 14 Pro Max molds are mainly provided for screen protector and lens protector accessories manufacturers to develop accessories, mainly because the details of the punch-hole screen on the front of the iPhone 14 Pro are quite delicate, whether it is the screen frame and lens holes, confirming that the iPhone 14 The Pro series bangs will be replaced by punch-hole screens, which will be combined in the shape of pills and round holes, mainly reserved for the Face ID sensor and front lens module, and the punch-hole shape of the iPhone 14 screen will also show an “i” exclamation point shape.
In addition, the mold opening drawings of iPhone 14 Pro accessories are also exposed with the mold. The details of the screen and the fuselage can be seen in the drawings. The screen punch is also located in the central area at the top of the fuselage. The data also shows that the height of the 6.7-inch iPhone 14 Pro screen is 160.71 mm. Slightly smaller than the previous generation’s 160.8 mm.
Mr. Crazy also found that the punch-hole screen design of the iPhone 14 Pro reduced the original bangs area once more. Originally, the iPhone 13 Pro had four important lens components in the bangs, until the iPhone 14 Pro was reduced to three components, and the rest were all hidden on the screen Below, it is beneficial to increase the screen ratio of the iPhone, but the iPhone 14 and iPhone 14 Max models will maintain the traditional bangs shape.
In addition to the iPhone 14 Pro series to browse overseas, this year’s iPhone 14 lens is also a highlight of the new machine, and the iPhone 14 Pro Max body size, thickness and lens height data are clearly marked from the accessories opening drawings.
According to the iPhone 14 Pro Max mold opening diagram, the thickness of the lens and the body is 12.02 mm. If the thickness of the body is only 7.85 mm, it means that the thickness of the lens module is 4.17 mm, which also means that the height of the lens module of the iPhone 14 Pro Max will reach 7.85 mm. About the thickness of two one-dollar coins, the lens will definitely protrude more than the previous generation lens.
It will cause the lens of the iPhone 14 Pro and iPhone 14 Pro Max to protrude more, mainly because the lens will be increased from the original 12 million pixels to 48 million pixels, and the 48MP CMOS image sensor (CIS) will also increase to 25% to 30%, It will cause the thickness of the lens to be more convex. Even the front lens of the iPhone 14 series will support “autofocus (AF)”. Compared with the previous series, which adopts fixed focus, the performance of Selfie, portrait mode and video recording has been significantly improved. The unit pixel area of the wide-angle lens is 1.22µm. The level of photography will usher in significant changes.
The iPhone 14 mold is not the first to appear, as early as mid-April, Mr. Crazy sharedFour iPhone 14 mold picturesbut at that time only the body size and lens changes might only be determined. Compared with the iPhone 14 Pro mold that came out this time, it was more refined than before, with more details on the front perforated screen and the back lens. If you want to know more regarding the complete details of the iPhone 14, You can refer to the lazy bag organized by Mr. Crazy:
